![]() ![]() Some areas restrict water heater installation to electricians with a permit. But often, an electrician will have to come in to rewire the system. Occasionally a plumber will have the skills to install a water heater on their own. Do you need an electrician to install a water heater? Think twice before attempting to do this yourself, then call All Dry USA for some expert help. There is a risk of injury when working with pressurized systems. It takes a professional with the right tools and plenty of experience to install a gas water heater. Turn on the control knob and set the temperature to between 118 and 123☏.įrequently Asked Questions Can you install a gas water heater yourself? You will need to remove the access panel to reach the controls. Use a match to light the pilot and hold down the reset button on the control box for one minute after the pilot has ignited. Light Pilot and Switch Control Knob to “On”.Apply a gas leak detection solution to any new fittings and connections to test for leaks. Turn on a hot water faucet while you do this to release any excess air from the system. Turn on the water system and open the water valve to fill the tank with new water. Attach the heater parts that connect to the gas supply line and tighten with your pipe wrench. Connect the Gas Supply to the New Heater.Reconnect the water line, attach the pressure relief valve and the drain line, and wrap the threads with thread seal tape. Tighten with your pipe wrench or solder as needed. Affix with fittings following directional arrows. Attach Heat Trap Fittings and Water Line Connections.Using your screwdriver, attach the flue hat to the new gas exhaust vent. Leave six inches of clearance on each side for proper ventilation. When it’s removed, dispose of your old water heater responsibly. Remove the overflow pipe and pressure release valve, but don’t discard them! You’ll reattach them later when installing the new unit. Using either a pipe wrench or tubing cutters as needed, disconnect or cut the existing gas and water lines. Attach a hose to the drain valve and let the excess water flow into a bucket or floor drain. This will drain the existing hot water from the tank. Then turn on a hot water faucet and let it run until the water runs cold. Turn off the water supply, the gas supply, and the control valve on the heater. Before you can remove the existing water heater, you’ll have to drain the tank. At the control panel, make sure the water temperature is set to 120 degrees Fahrenheit. Set the Heater to the Proper Temperature.At this point, you should turn on the propane and plug the new water heater into an electrical outlet. To make sure that everything is properly affixed, open the main water valve and see if there are any leaks. Turn on the Water for an Initial Test.Solder all of the connections to ensure a proper seal. Connect the existing water supply line to the new heater using copper pipes. Affix the threaded gas pipe to the new water heater using a union fitting. Make sure to tighten all connections with your pipe wrench. Using threaded iron pipes, set up a connection between your outdoor propane tank and the new water heater. After cutting the pipes, remove the old heater and set the new one in place to be installed. To remove the existing water heater, cut the water supply pipes that are attaching it to the wall using your tubing cutters. At the meter, turn off the main water valve before you begin working. ![]() Keep reading to learn the relevant instructions according to which model you have. Installation instructions will be slightly different depending on whether your propane water heater uses a tank or is tankless. The main tools you’ll need to complete this task is a pipe wrench, tubing cutters, and a propane torch. If you are experienced and knowledgeable in this area, this step-by-step list will help walk you through the process. Those unfamiliar with the plumbing installation should reach out to experts in this field. Installing a propane water heater is a difficult task involving an advanced level of skill. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |